Ball Mark Protocol

This protocol is a standardized way of verify whether a ball has landed in or out.

Impor­tant

New since 2023:

Teams can challenge an in/out decision up to a maximum of 5 seconds after the end of a rally. For this, one of the players shows a "C" to the 1st referee and then points to the line. This challenge is not possible during side changes.

A maximum of two unsuccessful challenges per team per set.

Procedure

• The first referee has to decide to initiate a ball mark protocol immediately after he whistles the ball dead.
• The first referee leaves his stand and walks to the ball mark. If available, the responsible line judge should meet the referee near the ball mark.
• Players can never participate in a ball mark protocol and have to be sent away if they approach the area.
• Once the first referee has collected all needed information (identifying the ball mark, possible explanation by the line judge), he should get back on the referee stand without signaling any decision made. Back in position, the first referee shows the next serving team as well as the appropriate hand signal.
• If necessary, a sanction can be applied if a team interfered with the ball mark protocol.

Remarks

• The second referee has to make sure that the team on the opposite side of the ball mark does not cross to the opponents‘ side of the court.
• Once the first referee has shown his decision, the second referee has to make sure that the scorer records the decision by the first referee and on the scoresheet.
• The decision of the first referee is final and no discussion should be allowed.